Chapter 10 Switch Setup
Figure 43 Switch Setup
The following table describes the labels in this screen.
Table 15 Switch Setup
LABEL | DESCRIPTION |
MAC Address | Enter a time from 10 to 10,000 seconds. This is how long all dynamically |
Learning | learned MAC addresses remain in the MAC address table before they age out |
Aging Time | (and must be relearned). Enter 0 to disable the aging out of MAC addresses. |
|
|
| GARP Timer: Switches join VLANs by making a declaration. A declaration is |
| made by issuing a Join message using GARP. Declarations are withdrawn by |
| issuing a Leave message. A Leave All message terminates all registrations. |
| GARP timers set declaration timeout values. Click here for more information on |
| VLANs. |
|
|
Join Timer | Join Timer sets the duration of the Join Period timer for GVRP in milliseconds. |
| Each port has a Join Period timer. The allowed Join Time range is between 100 |
| and 65535 milliseconds; the default is 200 milliseconds. |
|
|
Leave Timer | Leave Timer sets the duration of the Leave Period timer for GVRP in |
| milliseconds. Each port has a single Leave Period timer. Leave Time must be |
| two times larger than Join Timer; the default is 600 milliseconds. |
|
|
Leave All Timer | Leave All Timer sets the duration of the Leave All Period timer for GVRP in |
| milliseconds. Each port has a single Leave All Period timer. Leave All Timer |
| must be larger than Leave Timer. |
|
|
Port Isolation | Turn on port isolation to block communications between subscriber ports. When |
Active | you enable port isolation you do not need to configure the VLAN to isolate |
| subscribers. |
100 |
| |
| ||
|
|
|