Chapter 52 ADSL Commands

This next example creates a similar premium profile (named goldi), except it sets an interleave delay of 16 ms for both upstream and downstream traffic.

Figure 217 DSL Port Profile Set Command Example 2

ras> adsl profile set goldi interleave=16,16 1200 24000 5 0 30 128 5 0 30 256 0 6 0 6

After you create a DSL profile, you can assign it to any of the DSL ports on the IES-612-51A.

52.1.6 DSL Port Profile Delete Command

Syntax:

ras> adsl profile delete <profile>

where

<profile>

= A profile name.

This command allows you to delete an individual DSL profile by its name. You cannot delete a profile that is assigned to any of the DSL ports in the IES-612-51A. Assign a different profile to any DSL ports that are using the profile that you want to delete, and then you can delete the profile.

The following example deletes the gold DSL profile.

Figure 218 DSL Port Profile Delete Command Example

ras> adsl profile delete gold

52.1.7 DSL Port Profile Map Command

Syntax:

ras> adsl profile map <portlist> <profile> -> <glitegdmtt1413autoadsl2adsl2+>

where

<portlist>

=

You can specify a single DSL port <1>, all DSL ports <*>

 

 

or a list of DSL ports <1,3,5>. You can also include a range

 

 

of ports <1,5,6~10>.

<profile>

=

The profile that will define the settings of this port.

<glitegdmtets

=

The ADSL operational mode.

it1413autoad

 

 

sl2adsl2+>

 

 

This command assigns a specific profile to an individual port and sets the port’s operational mode (or standard). The profile defines the maximum and minimum upstream/downstream rates, the target upstream/downstream signal noise margins, and the maximum and minimum upstream/downstream acceptable noise margins of all the DSL ports to which you assign the profile.

When set to auto, the port follows whatever mode is set on the other end of the line.

 

347

IES-612-51A User’s Guide