52
ADSL Commands
This chapter describes some of the commands that allow you to configure and monitor the DSL ports.
52.1 DSL Port Commands
Use these commands to configure the DSL ports. See Chapter 13 on page 107 for background information on DSL and ADSL.
52.1.1 DSL Port Show Command
Syntax:
ras> adsl show [portlist]
where
[portlist] | = You can specify a single DSL port <1>, all DSL ports <*> or |
| a list of DSL ports <1,3,5>. You can also include a range of |
| ports <1,5,6~10>. |
This command shows the activation status, operational mode, maximum upstream and downstream rate settings, profile and name of each DSL port.
The following example displays information on DSL port 5.
Figure 214 DSL Port Show Command Example
ras> | adsl show 5 | up/downstream | profile | name | |
port | enable | mode | |||
5 | - | auto | 512/ 2048 | DEFVAL | - |
|
|
|
|
|
|
52.1.2 DSL Port Enable Command
Syntax:
ras> adsl enable <portlist>
| 343 |
|
|