Chapter 53 Virtual Channel Management Commands

<acname>

=

This field is optional. Specify the hostname of a remote

 

 

access concentrator if there are two access concentrators (or

 

 

BRAS) on the network or that you want to allow PAE

 

 

translation to the specified access concentrator.

<srvcname>

=

This field is optional. Specify the name of the service that

 

 

uses this PVC. This must be a service name that you

 

 

configure on the remote access concentrator.

<hellotime>

=

0 - 600; specify the timeout, in seconds, for the PPPoE

 

 

session. Enter 0 if there is no timeout.

This command creates a PPPoA-to-PPPoE PVC to allow communication between the ATM (CPE) and Ethernet network (BRAS) segments. The PVC is mapped to a PPPoE session that connects to the specified BRAS.

The following example creates a PPPoA-to-PPPoE PVC (1/33) for port 1. The VLAN ID is 1, and the IEEE 802.1p priority is 0. This configuration is for the video service on the vom access concentrator. The switch waits 10 seconds before terminating the PPPoE session.

Figure 283 PAE PVC Set Command Example

ras> adsl paepvc set 1 1 33 DEFVAL 1 0 acname vom srvcname video hellotime 10

53.8.3 PAE PVC Show Command

Syntax:

ras> adsl paepvc show <portlist> [<vpi> <vci>]

where

<portlist>

=

The port number of the PAE PVC. You can specify a single

 

 

DSL port <1>, all DSL ports <*> or a list of DSL ports

 

 

<1,3,5>. You can also include a range of ports <1,5,6~10>.

<vpi>

=

The VPI of the PAE PVC.

<vci>

=

The VCI of the PAE PVC.

This command displays the PPPoA-to-PPPoE PVC settings for the specified port(s) or PVCs. The following example displays the settings for port 1.

 

393

IES-612-51A User’s Guide