12

ENET Port Setup

The ENET Port Setup screen allows you to configure settings for the Ethernet ports.

To open this screen, click Basic Setting, ENET Port Setup.

Figure 45 ENET Port Setup

The following table describes the labels in this screen.

Table 17 ENET Port Setup

LABEL

DESCRIPTION

Port

This is the port index number.

 

 

Active

Select the check box to turn on the port. Clear it to disable the port.

 

 

Name

Enter a descriptive name that identifies this port. You can use up to 31 ASCII

 

characters; spaces are allowed.

 

 

Speed Mode

Select the type of Ethernet connection for this port. When you don’t use auto-

 

negotiation, you must make sure that the settings of the peer Ethernet port are

 

the same in order to connect.

 

Select Auto (auto-negotiation) to have the IES-612-51A automatically

 

determine the type of connection that the Ethernet port has. When the peer

 

Ethernet device has auto-negotiation turned on, the IES-612-51A negotiates

 

with the peer to determine the connection speed. If the peer Ethernet port does

 

not have auto-negotiation turned on, the IES-612-51A determines the

 

connection speed by detecting the signal on the cable and using full duplex.

 

Select 10 Copper if the Ethernet port has a 10 MB electrical connection.

 

Select 100 Copper if the Ethernet port has a 100 MB electrical connection.

 

 

Duplex

The IES-612-51A uses full duplex Ethernet connections by default.

 

 

Apply

Click Apply to save your changes to the IES-612-51A’s volatile memory. The

 

IES-612-51A loses these changes if it is turned off or loses power, so use the

 

Config Save link on the navigation panel to save your changes to the non-

 

volatile memory when you are done configuring.

 

 

Cancel

Click Cancel to begin configuring this screen afresh.

 

 

 

105

IES-612-51A User’s Guide