Chapter 53 Virtual Channel Management Commands

•The IES-612-51A’s management IP address should not be in the same subnet as the one defined by the WAN IP address and netmask of the subscriber’s device. It is suggested that you set the netmask of the subscriber’s WAN IP address to 32 to avoid this problem.

•The IES-612-51A's management IP address should not be in the same subnet range of any RPVC and RPVC domain. It will make the IES-612-51A confused if the IES-612-51A receives a packet with this IP as destination IP.

•The IES-612-51A’s management IP address also should not be in the same subnet as the one defined by the LAN IP address and netmask of the subscriber’s device. Make sure you assign the IP addresses properly.

•In general deployment, the computer must set the CPE device’s LAN IP address (10.10.10.10 in this example) as its default gateway.

•The subnet range of any RPVC and RPVC domain must be unique.

Use the following command sequence to configure the IES-612-51A for this example set up.

Figure 270 2684 Routed Mode Commands Example

ras> adsl rpvc gateway set 192.168.10.102 1

ras> adsl rpvc set 1 8 35 DEFVAL 192.168.10.200/32 192.168.10.102 ras> adsl rpvc route set 1 8 35 10.10.10.1/24

53.7.2 RPVC Gateway Set Command

Syntax:

ras> adsl rpvc gateway set <gateway ip> <vlan id> [<priority>]

where

<gateway ip>

=

The IP address of the gateway to which you want to send the

 

 

traffic that the system receives from this PVC. Enter the IP

 

 

address in dotted decimal notation.

<vlan id>

=

The VLAN Identifier to add to Ethernet frames that the

 

 

system routes to this gateway.

[<priority>]

=

Set the IEEE 802.1p priority (0~7) to add to the traffic that

 

 

you send to this gateway.

This command adds a gateway IP address to use for 2684 routed mode traffic.

The following example has the device use a VLAN ID of 1 and IEEE 802.1p priority of 3 when sending 2684 routed mode traffic to a gateway at IP address 192.168.10.102.

Figure 271 RPVC Gateway Set Command Example

ras> adsl rpvc gateway set 192.168.10.102 1 3

53.7.3 RPVC Gateway Show Command

Syntax:

ras> adsl rpvc gateway show

 

385

IES-612-51A User’s Guide