Chapter 52 ADSL Commands

52.2.3 Lineinfo Command

Syntax:

ras> statistics adsl lineinfo <portlist>

where

<portlist>

= You can specify a single DSL port <1>, all DSL ports <*>

 

or a list of DSL ports <1,3,5>. You can also include a range

 

of ports <1,5,6~10>.

This command shows the line operating values of a DSL port.

An example is shown next.

Figure 243 Lineinfo Command Example

ras> statistics adsl lineinfo 8 [port 8]

operating modes:

- service type in operation: adsl2+

- TRELLIS operation mode : on connection detail:

-down/up stream interleaved delay (ms): 3/ 2

-total transceiver DS output power (dbm): -2.5

-total transceiver US output power (dbm): 11.5

atuc information:

- vendor id: 30304235303035300000000000000000

-version number: 66323330323030300000000000000000

-serial number : 30323030306530336539303030370000000000000000000000000000000000 00

atur information:

- vendor id: b5004244434d00000000000000000000

-version number: 41327042303139610000000000000000

-serial number : 0000000000000000000000000000000000000000000000000000000000000000

The service type in operation is the ADSL standard that the port is using: G.dmt, G.dmt Annex B, G.lite, ANSI T1.413 issue 2, ADSL2, or ADSL2+.

Trellis coding helps to reduce the noise in DSL transmissions. Trellis may reduce throughput but it makes the connection more stable.3

The numbers of milliseconds of interleave delay for downstream and upstream transmissions are listed. The total output power of the transceiver varies with the length and line quality. The farther away the subscriber’s DSL modem or router is or the more interference there is on the line, the higher the power will be. “DS” refers to the power output of the IES-612-51A “US” refers to the power output of the subscriber’s DSL modem or router.

Information obtained prior to training to steady state transition will not be valid or will be old information.

3.At the time of writing, the IES-612-51A always uses Trellis coding.

 

359

IES-612-51A User’s Guide