Chapter 5 Initial Configuration

"If you change the IP address of the IES-612-51A, after you click Apply IP setting, you have to use the new IP address to log into the web configurator again.

4If your subscribers use VPI 0 and VCI 33 (the default for all of the DSL ports), go to step 13. Otherwise, use the following steps to change the VPI and VCI settings for all of the DSL ports.

First, you will delete the default virtual channel from all of the DSL ports. (You cannot edit it). Then, you will configure a new virtual channel for a port and copy it to the other DSL ports.

Adding another virtual channel without deleting the default virtual channel is not recommended since you cannot set the new channel to be the port’s super channel. The super channel can forward frames belonging to multiple VLAN groups (that are not assigned to other channels). A channel that is not the super channel can only forward frames with a single VLAN ID (that is configured on that channel). In this case, the IES-612-51A drops any frames received from the subscriber that are tagged with another VLAN ID.

5In the navigation panel, click Basic Setting, xDSL Port Setup. The xDSL Port Setup screen appears.

Figure 21 xDSL Port Setup

6Click VC Setup. The following screen appears.

70

 

IES-612-51A User’s Guide