Chapter 14 xDSL Profiles Setup

The following table describes the labels in this screen.

Table 28 IGMP Filter Profile

LABEL

DESCRIPTION

Port Profile

Click Port Profile to configure port profiles and assign them to individual ports

 

(see Section 14.1 on page 125).

 

 

VC Profile

Click VC Profile to open the VC Profile screen where you can configure virtual

 

channel profiles (see Section 14.5 on page 131).

 

 

Alarm Profile

Click Alarm Profile to open the Alarm Profile screen where you can configure

 

limits that trigger an alarm when exceeded (see Section 14.6 on page 133)

 

 

Index

This is the number of the IGMP filter profile. Click a profile’s index number to

 

edit the profile. You cannot edit the DEFVAL profile.

 

 

Name

This name identifies the IGMP filter profile.

 

 

Delete

Select the Delete check box and click Delete to remove an IGMP filter profile.

 

You cannot delete the DEFVAL profile.

 

 

Name

Type a name to identify the IGMP filter profile (you cannot change the name of

 

the DEFVAL profile). You can use up to 31 ASCII characters; spaces are not

 

allowed.

 

 

Start IP

Enter the starting multicast IP address for a range of multicast IP addresses to

 

which you want this IGMP filter profile to allow access.

 

 

End IP

Enter the ending multicast IP address for a range of IP addresses to which you

 

want this IGMP filter profile to allow access.

 

If you want to add a single multicast IP address, enter it in both the Start IP and

 

End IP fields.

 

 

Add

Click Add to save your changes to the IES-612-51A’s volatile memory. The IES-

 

612-51A loses these changes if it is turned off or loses power, so use the Config

 

Save link on the navigation panel to save your changes to the non-volatile

 

memory when you are done configuring.

 

 

Cancel

Click Cancel to start configuring the screen again.

 

 

136

 

IES-612-51A User’s Guide