Chapter 4 Introducing the Web Configurator
Table 4 Web Configurator Screens (continued)
LABEL | DESCRIPTION |
IP Setup | Use this screen to configure the system and management IP addresses and |
| subnet masks. |
|
|
ENET Port Setup | Use this screen to configure settings for the Ethernet ports. |
|
|
xDSL Port Setup | Use these screens for configuring settings for individual DSL ports. |
|
|
xDSL Profiles Setup | Use these screens for configuring profiles for the DSL ports. |
|
|
xDSL Line Data | Use these screens for viewing DSL line operating values, bit allocation and |
| performance counters. |
|
|
Advanced |
|
Application |
|
|
|
VLAN | Use these screens for viewing and configuring the VLAN settings. |
|
|
IGMP | Use these screens to view IGMP status information and configure IGMP |
| settings and IGMP filters. You can also use these screens to set up bandwidth |
| requirements by multicast group or port and to set up limits on the number of |
| multicast groups to which a port can subscribe. |
|
|
Static Multicast | Use this screen to configure static multicast entries. |
|
|
Multicast VLAN | Use these screens to set up multicast VLANs that can be shared among |
| different subscriber VLANs on the network. |
|
|
Filtering | Use this screen to configure packet filtering. |
|
|
MAC Filter | Use this screen to configure MAC filtering for each port. |
|
|
Spanning Tree | Use these screens to display Rapid Spanning Tree Protocol (RSTP) information |
Protocol | and configure RSTP settings. |
|
|
Port Authentication | Use these screens to configure RADIUS and IEEE 802.1x security settings. |
|
|
Port Security | Use this screen to limit the number of MAC address that can be learned on a |
| port. |
|
|
DHCP Relay | Use this screen to configure the DHCP relay settings. |
|
|
DHCP Snoop | Use these screens to drop traffic from IP addresses not assigned by the DHCP |
| server and to look at a summary of the DHCP packets on each port. |
|
|
2684 Routed Mode | Use this screen to configure the |
| traffic. |
|
|
PPPoA to PPPoE | Use this screen to enable |
|
|
DSCP | Use this screen to set up DSCP on each port and to convert DSCP values to |
| IEEE 802.1p values. |
|
|
TLS PVC | Use this screen to set up Transparent LAN Service (VLAN stacking, |
| each port. |
|
|
ACL | Use this screen to set up Access Control Logic profiles and to assign them to |
| each PVC. |
|
|
Downstream | Use this screen to block downstream broadcast packets from being sent to |
Broadcast | specified VLANs on specified ports. |
|
|
SysLog | Use this screen to configure the syslog settings. |
|
|
Access Control | Use this screen to configure service access control and configure SNMP and |
| remote management. |
|
|
Routing Protocol |
|
|
|
Static Routing | Use this screen to configure static routes. A static route defines how the IES- |
| |
|
|
Alarm |
|
|
|
64 |
| |
| ||
|
|
|