Chapter 40 Alarm
Table 86 Alarm Event Setup Edit (continued)
LABEL | DESCRIPTION |
Apply | Click Apply to save your changes to the |
| |
| Config Save link on the navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Close | Click Close to exit the screen without saving your changes. |
|
|
40.5 Alarm Port Setup Screen
Use this screen to set the alarm severity threshold for recording alarms on an individual port(s). The system reports an alarm on a port if the alarm has a severity equal to or higher than the port’s threshold.
To open this screen, click Alarm, Alarm Port Setup.
Figure 132 Alarm Port Setup
The following table describes the labels in this screen.
Table 87 Alarm Port Setup
LABEL | DESCRIPTION |
Alarm Status | Click Alarm Status to go to a screen that displays the alarms that are currently |
| in the system (see Section 40.2 on page 249). |
|
|
Alarm Event Setup | Click Alarm Event Setup to go to a screen where you can configure the |
| severity level of an alarm(s) and where the system is to send the alarm(s). See |
| |
|
|
Port | This column lists the device’s individual DSL and Ethernet interfaces. |
|
|
Severity | Select an alarm severity level (critical, major, minor or info) as the threshold for |
| recording alarms on this port. Critical alarms are the most severe, major alarms |
| are the second most severe, minor alarms are the third most severe and info |
| alarms are the least severe. |
|
|
Apply | Click Apply to save your changes to the |
| |
| Config Save link on the navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to start configuring the screen again. |
|
|
254 |
| |
| ||
|
|
|