Chapter 45 IEEE 802.1Q Tagged VLAN Commands

45.4.8Configuring Management VLAN Example

"After the following example configuration, you must connect to the first Ethernet port through a VLAN aware device that is using the proper VLAN ID in order to perform management.

By default, the IES-612-51A’s DSL ports are members of the management VLAN (VID 1). The following procedure shows you how to configure a tagged VLAN that limits management access to just one Ethernet port.

"Use the console port to configure the IES-612-51A if you misconfigure the management VLAN and lock yourself out.

1Use the switch vlan set command to configure a VLAN ID (VID 3 in this example) for managing the IES-612-51A (the “management” or “CPU” VLAN).

Figure 157 CPU VLAN Configuration and Activation Example

ras> switch vlan set 3 enet1:FT

2Use the switch vlan1q vlan cpu command to set VID 3 as the management VLAN.

Figure 158 Deleting Default VLAN Example

ras> switch vlan cpu set 3

45.4.9 VLAN Delete Command

Syntax:

ras> switch vlan delete <vlanlist>

where

<vlanlist>

= You can specify a single VID: <1>, all VIDs: <*>, a list of

 

VIDs: <1,3>, you can also include a range of VIDs:

 

<1,5,6~10>.

This command deletes the specified VLAN ID entry from the static VLAN table. The following example deletes entry 2 in the static VLAN table.

Figure 159 VLAN Delete Command Example

ras> switch vlan delete 2

304

 

IES-612-51A User’s Guide