![](/images/backgrounds/127096/127096-444210x1.png)
Chapter 29 DSCP
Table 65 DSCP Setup (continued)
LABEL | DESCRIPTION |
Select | Select this, and click Active or Inactive to enable or disable the DSCP on this |
| port. |
|
|
Active | Click this to enable DSCP on the selected ports. |
|
|
Inactive | Click this to disable DSCP on the selected ports. |
|
|
All | Click this to select all entries in the table. |
|
|
None | Click this to |
|
|
29.3 DSCP Map Screen
Use this screen to convert DSCP priority to IEEE 802.1p priority. To open this screen, click Advanced Application, DSCP, DSCP Map.
Figure 105 DSCP MapThe following table describes the labels in this screen.
Table 66 DSCP MapLABEL | DESCRIPTION |
DSCP Map | Click DSCP Setup to open the screen where you can activate or deactivate |
| DSCP on each port (see Section 29.2 on page 209). |
|
|
Source DSCP | This field displays each DSCP value. |
|
|
802.1P Priority | Enter the IEEE 802.1p priority to which you would like to map this DSCP value. |
|
|
Apply | Click Apply to save your changes to the |
| |
| Config Save link on the navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
210 |
| |
| ||
|
|
|