Cambridge SoundWorks manual P460-1#set port redundancy-intervals 100, Set port spantree

Chapter 2 Avaya P460 CLI Commands

switchback-interval	The period the primary port link has to be
	“up” before the system switches back (in
	milliseconds).
	• If switchback interval is zero, the system
	never switches back
	• If it is one, switchback occurs immediately
	after the primary port link returns
none	The system switches bank only if the

secondary link fails.

Example:

P460-1#set port redundancy-intervals 100 20

set port spantree

User level: read-write, admin.

Use the set port spantree command to enable or disable the spanning tree mode for specific switch ports.

The syntax for this command is:

set port spantree {enabledisable} [module/port]

enabledisable	Enables or disables the spanning tree mode for the
	specified ports.
Module	Module number
Port	Port number
Example:

P460-1#set port spantree enable 3/1 port 3/1 was enabled on spantree

set port spantree cost

User level: read-write, admin.

Use the set port spantree cost command to set the cost of a port. This value defines which port will be allowed to forward traffic if two ports with different costs

96 Avaya P460 Reference Guide