Chapter 2 Avaya P460 CLI Commands

Example:

To set the time until the system disconnects an idle session automatically to 20 minutes:

P460-1#set logout 20

Sessions will be automatically logged out after 20 minutes of idle time.

set outband duplex

User level: read-write, admin.

Use the set outband duplex command to configure the duplex type of the Ethernet Console port.

You can configure the Ethernet Console interface to either full duplex or half duplex.

The duplex status of a port in auto-negotiation mode is determined by auto- negotiation and an error message is generated if you attempt to set the transmission type of auto-negotiation Fast Ethernet ports to half- or full-duplex mode.

The syntax for this command is:

set outband duplex {full half}

Full

Specifies full-duplex transmission.

Half

Specifies half-duplex transmission

Example:

 

P460-1#set outband duplex full

Ethernet Console interface set to full-duplex.

set outband negotiation

User level: read-write, admin.

Use the set outbound negotiation command to enable or disable the link negotiation protocol on the Ethernet console port.

This command applies to the specific supervisor module where you execute it.

When negotiation is enabled, the speed and duplex of the outband Ethernet port is determined by auto-negotiation.

If negotiation is disabled, you can set the speed and duplex of the outband Ethernet port.

Avaya P460 Reference Guide

83

Page 93
Image 93
Cambridge SoundWorks manual P460-1#set logout, Set outband duplex full half, P460-1#set outband duplex full