Chapter 2

Avaya P460 CLI Commands

This chapter describes all the P460 CLI commands and parameters in alphabetical order.

area

User level: read-write, admin.

You can only access this command in Router-OSPF mode.

Type router ospf at the command prompt to enter Router -OSPF mode if necessary.

Use the area command to configure the area ID of the router.

Use the no area command to deleted the area ID of the router (set it to 0) and remove the stub definition.

The default area is 0.0.0.0.

Note: You cannot define a stub area when OSPF is redistributing other protocols or when the Area ID is 0.0.0.0.

The syntax for this command is:

[no] area <area id> [<stub>]

area id

IP address

stubStub

Example:

Router-1 (configure router:ospf) # area 192.168.49.1

Router-1 (configure router:ospf) # area 192.168.49.1 stub

arp

User level: read-write, admin.

You can only access this command in configure mode.

Type configure at the command prompt to enter configure mode.

Avaya P460 Reference Guide

13

Page 23
Image 23
Cambridge SoundWorks P460 manual Area, Arp