Chapter 2 Avaya P460 CLI Commands

traceroute

User level: read-only, read-write, admin.

Provides a trace route utility.

The syntax for this command is:

traceroute <host>

host

IP address.

Example:

Router-1>traceroute 192.168.50.13

timers spf

User level: read-write, admin.

You can only access this command in Router-OSPF mode.

Type router ospf at the command prompt to enter Router -OSPF mode if necessary.

Use the timers spf command to set the delay between runs of OSPF SPF calculation.

Use the no timers spf command to restore the default (3 seconds).

The syntax for this command is:

[no] timers spf <spf-holdtime>

spf-holdtime

The time in seconds of the delay between runs of

 

OSPF’s SPF calculation.

Example:

Router-1 (configure router:ospf) # timers spf 5

Done!

validate-group

User level: read-write, admin.

You can only access this command in Configure mode.

Type configure at the command prompt to enter Configure mode if necessary.

Avaya P460 Reference Guide

183

Page 193
Image 193
Cambridge SoundWorks P460 manual Traceroute host, Router-1traceroute, No timers spf spf-holdtime