Cambridge SoundWorks manual Show port trap, P460-1show port trap 4/1

Chapter 2 Avaya P460 CLI Commands

show port trap

User level: read-only, read-write, admin.

Use the show port trap command to display information on SNMP generic link up/down traps sent for a specific port.

The syntax for this command is:

show port trap [<module>[/<port>]]

module	Number of the module (3-6). If you do not specify a number,
(Optional)	the ports on all the modules are shown.
port	Number of the port on the module. If you do not specify a
(Optional)	number, all the ports on the module are shown.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.
Example:

P460-1>show port trap 4/1

Port 4/1 up/down trap is disabled

Avaya P460 Reference Guide 163