Chapter 2 Avaya P460 CLI Commands

ip admin-state

User level: read-write, admin.

You can only access this command in interface mode.

Type interface [name] at the command prompt to enter interface mode.

Use the admin-statecommand to set the administrative state of an IP interface. The default state is up.

The syntax for this command is:

ip admin-state <up/down>

up/down

Administrative state of the interface. The choices are

 

up (active) or down (inactive).

Example:

Router-1(config-if:marketing)# ip admin-state up

ip bootp-dhcp network

User level: read-write, admin.

You can only access this command in Interface mode.

Type interface [name] at the command prompt to enter Interface mode if necessary.

Use the ip bootp-dhcp network command to select the network from which the bootp/dhcp server shall allocate an address. You only need to run this command is required only when there are multiple interfaces over the VLAN.

Use the no ip bootp-dhcp network command to restore the default value.

The syntax for this command is:

[no] ip bootp-dhcp network <ip-address>

ip-address

The IP address of the network.

Example:

To select the network 192.168.169.0 as the network from which an address shall be

36

Avaya P460 Reference Guide

Page 46
Image 46
Cambridge SoundWorks P460 manual Ip admin-state up/down, Ip bootp-dhcp network, No ip bootp-dhcp network ip-address