Cambridge SoundWorks manual Set port disable module/port, P460-1#set port disable 4/1

Chapter 2 Avaya P460 CLI Commands

set port disable

User level: read-write, admin.

Use the set port disable command to disable a port or range of ports.

The syntax for this command is:

set port disable <module>/<port>

module	Number of the module (3-6). If you do not specify a number,
	the ports on all the modules are shown.
port	Number of the port on the module. If you do not specify a
	number, all the ports on the module are shown.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.
Example:

P460-1#set port disable 4/1

Port 4/1 disabled.

set port duplex

User level: read-write, admin.

Use the set port duplex command to configure the duplex type of an Ethernet or Fast Ethernet port or range of ports.You can configure Ethernet and Fast Ethernet interfaces to either full duplex or half duplex.

The duplex status of a port in auto-negotiation mode is determined by auto- negotiation. An error message is generated if you attempt to set the transmission type of auto negotiation Fast Ethernet ports to half- or full-duplex mode.

The syntax for this command is:

set port duplex <module>/<port> {fullhalf}

module	Number of the module (3-6). If you do not specify a number,
	the ports on all the modules are shown.
port	Number of the port on the module. If you do not specify a
	number, all the ports on the module are shown.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.

Avaya P460 Reference Guide 87