Cambridge SoundWorks manual P460-1#set port static-vlan 3/4-6, Set port trap, Set port vlan

Chapter 2 Avaya P460 CLI Commands

Example:

P460-1#set port static-vlan 3/4-6 2

VLAN 2 is bound to port 3/4

VLAN 2 is bound to port 3/5

VLAN 2 is bound to port 3/6

set port trap

User level: read-write, admin.

Use the set port trap command to enable or disable generic SNMP uplink or downlink traps from a port.

The syntax for this command is:

set port trap <module>/<port> {enabledisable}

module	Number of the module (3-6). If you do not specify a number,
	the ports on all the modules are shown.
port	Number of the port on the module. If you do not specify a
	number, all the ports on the module are shown.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.
enable	Enable uplink/downlink traps
disable	Disable uplink/downlink traps
Example:

P460-1#set port trap 3/2 enable

Port 3/2 up/down trap enabled.

set port vlan

User level: read-write, admin.

Use the set port vlan command to set the port VLAN ID (PVID). If adding a new VLAN, the VLAN number must be within the range.

You need to define a vlan before setting a port VLAN ID.

Avaya P460 Reference Guide 99