Chapter 1

Using the CLI

This chapter describes the Avaya P460 CLI architecture and conventions, and provides instructions for accessing the Avaya P460 for configuration purposes.

The configuration procedure involves establishing a Telnet session or a serial connection and then using the Avaya P460’s internal CLI. For details on establishing a connection, see the User’s Guide that accompanies the switch.

The CLI is command-line driven and does not have any menus. To activate a configuration option, you must type the desired command at the prompt and press Enter.

You can also configure your Avaya P460 using the P460 Manager with its graphical user interface. For details, see the "Device Manager" chapter in the User’s Guide that accompanies the switch and the Avaya MSNM P460 Device Manager User’s Guide on the Documentation and Utilities CD.

CLI Architecture

The P460 supports both Layer 2 switching and Layer 3 switching.

The P460 CLI includes two CLI entities to support this functionality.

The Switch CLI entity is used to manage Layer 2 switching.

The Router CLI entity is used to manage Layer 3 switching.

To switch between the entities, use the session command. For details, see "Avaya P460 Sessions" below.

Configuration of the password commands and community commands in one entity is automatically attributed to the other entity in the switch.

Avaya P460 Reference Guide

1

Page 11
Image 11
Cambridge SoundWorks P460 manual Using the CLI