
Chapter 1 | Using the CLI |
|
|
Avaya P460 Sessions
You can use sessions to switch between P460 Supervisor modules or to switch between Layer 2 and Layer 3 commands in the P460 CLI.
To switch between P460 modules use the command: session [<mod_num>] <mode>.
The <mod_num> is the number of the module in the chassis, counting from the top down. The <mode> can be either switch or router. When Module Number is not specified, the command switches between the modes in the local module. Use switch mode to configure layer 2 commands. Use router mode to configure routing commands.
Example:
To configure router parameters in the module that you are currently logged into, type the following command:
session router.
When you use the session command the security level stays the same.
8 | Avaya P460 Reference Guide |