Cambridge SoundWorks P460 manual Ip rip default-route-mode mode, Mode talk listen

Chapter 2 Avaya P460 CLI Commands

ip rip default-route-mode

User level: read-write, admin.

You can only access this command in interface mode.

Type interface [name] at the command prompt to enter interface mode if necessary.

Use the ip rip default-route-modecommand to enable learning of the default route received by the RIP protocol. The default state is talk-listen.

The syntax for this command is:

ip rip default-route-mode <mode>

The possible default route modes on an interface are:

talk-listen	Set RIP to send and receive default route updates on
	the interface.
talk-only	Set RIP to send but not receive default route updates
	on the interface.
Example:

Router-1(configure-if:marketing) # ip rip default-route-

mode talk listen

Done!

ip rip poison-reverse

User level: read-write, admin.

You can only access this command in interface mode.

Type interface [name] at the command prompt to enter interface mode if necessary.

Use the ip rip poison-reversecommand to enable split-horizon with poison-reverse on an interface.

Use the no ip poison-reversecommand to disable the poison-reverse mechanism.

The split-horizon technique prevents information about routes from exiting the router interface through which the information was received. This prevents routing loops.

Poison reverse updates explicitly indicate that a network or subnet is unreachable rather than implying they are not reachable. Poison reverse updates are sent to defeat large routing loops.

48 Avaya P460 Reference Guide