Chapter 2 Avaya P460 CLI Commands

Use the ip vrrp primary command to set the primary address that shall be used as the source address of VRRP packets for the virtual router ID.

Use the no ip vrrp primary command to return to the default primary address for the virtual router instance.

By default, the primary address is selected automatically by the device.

The syntax for this command is:

[no] ip vrrp <vr-id>primary <ip-address>

vr-id

Virtual Router ID (1-255)

ip-address

Primary IP address of the virtual router. This address

 

should be one of the router addresses on the VLAN.

Example:

 

Router-1(configure-if:marketing) # ip vrrp 1 primary

192.168.66.23

Done!

ip vrrp priority

User level: read-write, admin.

You can only access this command in Interface mode.

Type interface [name] at the command prompt to enter Interface mode if necessary.

Use the ip vrrp priority command to set the virtual router priority value used when selecting a master router.

Use the no ip vrrp priority command to restore the default value.

The syntax for this command is:

[no] ip vrrp <vr-id>priority <pri-value>

vr-id

Virtual Router ID (1-255)

pri-value

The priority value. The range is 1-254.

Avaya P460 Reference Guide

57

Page 67
Image 67
Cambridge SoundWorks P460 manual No ip vrrp vr-idprimary ip-address, 192.168.66.23, Ip vrrp priority