Chapter 2 Avaya P460 CLI Commands
set qos trust
User level: read-write, admin.
You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if necessary.
Use the set qos trust command to configure which of the incoming packet's priority parameters should be considered when determining the new assigned priority. You can configure the P460 to trust either the cos (the 802.1p priority), the dscp (the DSCP value), or neither. The default value is
The syntax for this command is:
set qos trust {untrusted
Example:
set radius authentication enable/disable
User level: read-write, admin.
Enables or disables RADIUS authentication for the P460 switch.
The syntax for this command is:
set radius authentication {enable disable}
enable | Enable RADIUS authentication |
disable | Disable RADIUS authentication (default) |
Example: |
|
P460-1(super)# set radius authentication enable
set radius authentication retry-number
User level: read-write, admin.
Sets the number of times an access request is sent when there is no response.
Avaya P460 Reference Guide | 105 |
