Cambridge SoundWorks P460 manual Set snmp trap auth, Set snmp trap enabledisable auth

Chapter 2 Avaya P460 CLI Commands

set snmp trap auth

User level: read-write, admin.

Use the set snmp trap auth command to enables or disable the sending of SNMP traps upon SNMP authentication failure.

The syntax for this command is:

set snmp trap {enabledisable} auth

Example:

P460-1#set snmp trap enable auth

Authentication trap enabled

set spantree enable/disable

User level: read-write, admin.

Use the set spantree command to enable or disable the spanning-tree algorithm for the switch.

When you disable STP, blocking ports are disabled in order to prevent loops in the network. As a result, you need to wait 30 seconds before disabling STP if you reset the switch, enable STP, or insert a new station.

The syntax for this command is:

set spantree {enabledisable}

Example:

P460-1#set spantree enable bridge spanning tree enabled.

P460-1#set spantree disable bridge spanning tree disabled.

112 Avaya P460 Reference Guide