Chapter 2 Avaya P460 CLI Commands

ports.

In auto-negotiation mode, the port's speed is determined by auto negotiation. An error message is generated if you attempt to set the speed when auto negotiation is enabled

The syntax for this command is:

set port speed <module>/<port> <10MB100MB1GB>

module

Number of the module (3-6). If you do not specify a number,

 

the ports on all the modules are shown.

port

Number of the port on the module. If you do not specify a

 

number, all the ports on the module are shown.

 

You can also specify a range of ports separated by a dash, for

 

example, 4/5-13 for ports 5 to 13 on module 4.

Example:

To configure port 1 on module 4 to 100 Mbps

P460-1#set port speed 4/1 100MB

Port 4/1 speed set to 100 Mbps.

set port static-vlan

User level: read-write, admin.

Use the set port static-vlancommand to assign static VLANs to ports.

The syntax for this command is:

set port static-vlan[module/port range] [vlan num]

module/port

Port range

range

 

vlan range

vlan to bind to port

98

Avaya P460 Reference Guide

Page 108
Image 108
Cambridge SoundWorks manual P460-1#set port speed 4/1 100MB, Set port static-vlan