Chapter 2 Avaya P460 CLI Commands
set port name
User level: read-write, admin.
Use the set port name command to configure a name for a port. If you do not specify a name, the port name remains blank.
The syntax for this command is:
set port name <module>/<port> [<name>]
module | Number of the module |
| the ports on all the modules are shown. |
port | Number of the port on the module. If you do not specify a |
| number, all the ports on the module are shown. |
| You can also specify a range of ports separated by a dash, for |
| example, |
name | Name (up to 16 characters) |
Example: |
|
P460-1# set port name 4/21 arthur
Port 4/21 name set.
If you wish to define a name which includes spaces, you must enclose the entire name in quotation marks, for example “new york”.
set port negotiation
User level: read-write, admin.
Use the set port negotiation command to enable or disable the link negotiation protocol on the specified port. This command applies to Fast Ethernet or Gigabit Ethernet ports.
When negotiation is enabled, the speed and duplex of the Fast Ethernet ports are determined by
If negotiation is disabled, the user can set the speed and duplex of the Fast Ethernet ports.
Avaya P460 Reference Guide | 93 |
