Cambridge SoundWorks manual Show outband, P460-1show outband, Show port, P460-1show port 3/4

Chapter 2 Avaya P460 CLI Commands

show outband

User level: read-only, read-write, admin.

Use the show outband command to displays the Ethernet Console port status.

This command applies to the specific supervisor module where you execute it.

The syntax for this command is:

show outband

Example:

P460-1>show outband

Status:	Connected
Auto-negotiation:	Enable
Duplex:	Half-Duplex
Speed:	100 MBit/sec

show port

User level: read-only, read-write, admin.

Use the show port command to display port status on I/O modules.

The syntax for this command is:

show port [<module>[/port]]

module	Number of the module (3-6). If you do not specify a number,
(Optional)	the ports on all the modules are shown.
port	Number of the port on the module. If you do not specify a
(Optional)	number, all the ports on the module are shown.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.

Example: to display the status for port 4 on switch 3

P460-1>show port 3/4

Port	Name	Status	Vlan	Level	Neg	Dup. Spd.	Type
------	---------------	---------	----	------	-------	---- ----	-----------------
3/4	NO NAME	no link	1	0	enable	half 10M	10/100BaseTx Port

Avaya P460 Reference Guide 157