Cisco Systems CSR 1000V manual Enter ? to display a list of all, Interface configuration commands

Chapter 2 Using Cisco IOS XE Software

Getting Help

Table 2-5 Finding Command Options (continued)

Command		Comment
Router(config-if)# ?		Enter ? to display a list of all the
Interface configuration commands:		interface configuration commands
.		available for the Gigabit Ethernet
.
		interface. This example shows only
.
		some of the available interface
ip	Interface Internet Protocol config commands
keepalive	Enable keepalive	configuration commands.
lan-name	LAN Name command
llc2	LLC2 Interface Subcommands
load-interval	Specify interval for load calculation for an
	interface
locaddr-priority	Assign a priority group
logging	Configure logging for interface
loopback	Configure internal loopback on an interface
mac-address	Manually set interface MAC address
mls	mls router sub/interface commands
mpoa	MPOA interface configuration commands
mtu	Set the interface Maximum Transmission Unit (MTU)
netbios	Use a defined NETBIOS access list or enable
	name-caching
no	Negate a command or set its defaults
nrzi-encoding	Enable use of NRZI encoding
ntp	Configure NTP
.
.
.
Router(config-if)#
		Enter the command that you want to
Router(config-if)# ip ?		configure for the interface. This
Interface IP configuration subcommands:		example uses the ip command.
access-group	Specify access control for packets
accounting	Enable IP accounting on this interface	Enter ? to display what you must enter
address	Set the IP address of an interface	next on the command line. This
authentication	authentication subcommands
		example shows only some of the
bandwidth-percent	Set EIGRP bandwidth limit
		available interface IP configuration
bgp	BGP interface commands
broadcast-address	Set the broadcast address of an interface	commands.
cef	Cisco Express Forwarding interface commands
cgmp	Enable/disable CGMP
dhcp	Configure DHCP parameters for this interface
.
.
.
Router(config-if)# ip
Router(config-if)# ip address ?		Enter the command that you want to
A.B.C.D	IP address	configure for the interface. This
dhcp	IP Address negotiated via DHCP	example uses the ip address command.
pool	IP Address autoconfigured from a local DHCP pool
Router(config-if)# ip address		Enter ? to display what you must enter
		next on the command line. In this
		example, you must enter an IP address
		or the negotiated keyword.
		A carriage return (<cr>) is not
		displayed; therefore, you must enter
		additional keywords or arguments to
		complete the command.

Cisco CSR 1000V Series Cloud Services Router Software Configuration Guide

OL-27477-07 2-5