Cisco Systems CSR 1000V Exits configuration mode and enters privileged, Exec mode, Settings, 15-6

Chapter 15 Configuring Support for Remote Management by the Cisco Prime Network Services Controller

Configuring Remote Management by Cisco Prime Network Services Controller

	Command or Action	Purpose
Step 5	end	Exits configuration mode and enters privileged
		EXEC mode.
	Example:
	Router(config-remote-mgmt)# end
Step 6	show remote-management status	Displays the Cisco CSR 1000V remote management
		settings.
	Example:
	Router# show remote-management status
	RESTful-API: enabled
	https port: 443
	PNSC CPA: enabled
	Host 172.27.208125 port 8443 shared-secret
	*******

Once remote management by Cisco Prime Network Services Controller is enabled, the following warning is displayed when entering the Cisco IOS XE CLI mode directly on the router:

WARNING: This device is managed by Prime Network Services Controller. RESTful API is read

only. Changing configuration using CLI is not recommended.

See the Cisco Prime Network Services Controller documentation for more information.

Disabling Remote Management by the Cisco Prime Network Services Controller Host

SUMMARY STEPS

1.enable

2.configure terminal

3.remote-management

4.no pnsc host ipv4-addrlocal-port number shared-secret string

Note When remote management by Cisco Prime Network Services Controller is disabled using this command, the REST API PUT, POST, and DELETE operations are enabled.

5.end

6.show remote-management status

	Cisco CSR 1000V Series Cloud Services Router Software Configuration Guide
15-6	OL-27477-07