Cisco Systems CSR 1000V - page 120

10-2
Cisco CSR 1000V Series Cloud Services Router Software Configuration Guide
OL-27477-07
Chapter10 Mapping Cisco CSR 1000V Network Interfaces to VM Network Interfaces
Mapping the Router Network Interfaces to Virtual Network Interface Cards
Figure10-1 vNICs Mapped to Cisco CSR 1000V Router Interfaces
After the Cisco CSR 1000V boots, you need to display the mapping between the logical interface on the
router with the vNIC and the vNIC MAC address using the show platform software vnic-if
interface-mapping command. The display for this command is different depending on your
Cisco IOS XE release version. The following is a sample display for Cisco IOS XE Release 3.9S:
Router# show platform software vnic-if interface-mapping
--------------------------------------------------------------------------
Interface Name Short Name vNIC Name Mac Addr
--------------------------------------------------------------------------
GigabitEthernet0 Gi0 eth0 (vmxnet3) 000c.2946.3f4d
GigabitEthernet2 Gi2 eth2 (vmxnet3) 0050.5689.0034
GigabitEthernet1 Gi1 eth1 (vmxnet3) 0050.5689.000b
--------------------------------------------------------------------------