Hitachi X200 Series instruction manual Additional Analog Input Settings

3−28

Additional Analog Input Settings

Configuring Drive Parameters

Input Range Settings – The parameters in the following table adjust the input characteristics of the analog current input. When using the inputs to command the inverter output frequency, these parameters adjust the starting and ending ranges for the current, as well as the output frequency range. Related characteristic diagrams are located in “Analog Input Settings” on page 3-13.

Analog sampling setting is the value specified in A016.

		“A” Function		Run		Defaults
Func.	Name /		Description	Mode -FE -FU				Units
Code	SRW Display			Edit (EU)			(USA)
A101	[OI]-[L] input active range		The output frequency		0.0		0.0	Hz
	start frequency		corresponding to the analog input
			range starting point,
	OI-EXS	0000.0Hz	range is 0.0 to 400.0 Hz
A102	[OI]-[L] input active range		The output frequency		0.0		0.0	Hz
	end frequency		corresponding to the current
			input range ending point,
			range is 0.0 to 400.0 Hz
	OI-EXE	0000.0Hz
A103	[OI]-[L] input active range		The starting point (offset) for the		0.		0.	%
	start current		current input range,
	OI-EX%S	00000%	range is 0. to 100.%
A104	[OI]-[L] input active range		The ending point (offset) for the		100.		100.	%
	end voltage		current input range,
	OI-EX%E	00000%	range is 0. to 100.%
A105	[OI]-[L] input start frequency		Two options; select codes:		01		01	−
	enable		00…Use offset (A101 value)
	OI-LVL	0Hz	01…Use 0Hz

Refer to parameter A011 to A015 for analog voltage input.

NOTE: You cannot give voltage input and current input ([O] and [OI] input) at the same time on X200 series inverter.