Hitachi X200 Series instruction manual Output frequency Real-time display of output

B−22

The following table lists holding registers for the “D” Group Monitor Functions.

Appendix B

List of Holding Registers

Func.	Name	R/W	Description		Network Data
Code				Reg.		Range	Res.
D001	Output frequency	R	Real-time display of output	1002h		0 to 4000	0.1 Hz
	monitor		frequency to motor, from 0.0 to
			400.0 Hz
D002	Output current	R	Filtered display of output	1003h		0 to 2000	0.1%
	monitor *1		current to motor (100 ms
			internal filter time constant),
			range is 0 to 200% of inverter
			rated current
D003	Rotation direction	R	Three different indications:	1004h		0,1,2	−
	monitor		00...Stop
			01...Forward
			02...Reverse
D004	Process Variable (PV),	R	Displays the scaled PID process	1005h		0 to	0.00%
(high)	PID feedback monitor		variable (feedback) value (A075			999900	times
D004		R	is scale factor), range is 0.00 to	1006h			const.
(low)			9999.00
D005	Intelligent input	R	Displays the state of the	1007h		0 to 63	−
	terminal status		intelligent input terminals [x],
			Bit 0 = [1] to Bit 4 = [5]
D006	Intelligent output	R	Displays the state of the	1008h		0 to 7	−
	terminal status		intelligent output terminals [x],
			Bit 0 = [11], Bit 1 = (Don’t Care),
			Bit 2 = [AL]
D007	Scaled output	R	Displays the output frequency	1009h		0 to	0.01 Hz
(high)	frequency monitor		scaled by the constant in B086.			3996000	times
D007		R	Decimal point indicates range:	100Ah			const.
(low)			0.00 to 39960.00
D013	Output voltage	R	Voltage of output to motor, range	100Ch		0 to	0.01%
	monitor		is 0.00 to 200.00%			20000
D016	Cumulative operation	R	Displays total time the inverter	100Eh		0 to	1 hour
(high)	RUN time monitor		has been in RUN mode in hours.			999999
D016		R	Range is 0 to 999999	100Fh
(low)
D017	Cumulative power-on	R	Displays total time the inverter	1010h		0 to	1 hour
(high)	time monitor		has been in RUN mode in hours.			999999
D017		R	Range is 0 to 999999	1011h
(low)
D018	Fin temperature	R	Display the Fin temperature in	116Ah		0 to 2000	0.1°C
	monitor		0.0~200.0°C
D080	Trip counter	R	Number of trip events, range is 0	0011h		0 to 65535	1 trip
			to 65535				event
D102	DC voltage monitor	R	Voltage of DC bus inside	116Ch		0 to 9999	0.1 V
			inverter,Range is 0.0 to 999.9
D104	Electronic thermal	R	Accumulated value of electronic	116Dh		0 to 1000	0.1 %
	monitor		thermal detection, range is from
			0.0 to 100.0

Note 1: Assume that the inverter current rating is 1000 (for D002).