05 SENDER ID
This function controls the printing of your fax machine’s Sender ID on the faxes you send.
Refer to “Installation, Programming Required
Information.”
When set to ON, the Sender ID will be printed on each page slightly outside the image area of your document.
The default setting is ON.
!In order to meet FCC requirements, you must have this feature set to ON and have a valid Sender ID
programmed in your fax machine.
06 MONITOR VOLUME
This function sets the volume for telephone line monitoring during dialing.
Available settings are LOW (default), HIGH, and OFF.
07 BUZZER VOLUME
This function sets the volume of the various tones your fax machine emits during operation. Available settings are LOW, MIDDLE (default), and HIGH.
08 CLOSED NETWORK
This function allows you to program your fax machine to refuse to communicate with locations whose telephone numbers have not been programmed into your
If you do not want your fax machine to transmit faxes to or receive faxes from locations outside your network, select T/R.
If you only want your fax machine to refuse to receive faxes from outside your network, select RX.
Available settings are OFF (default), T/R, and RX.
09 TX MODE DEFAULT
Your fax machine is set for the STD (standard) resolution setting and the NORMAL contrast setting. If you consistently send faxes that require some other combination of transmission modes, use this function setting to change the default modes. While you are programming, the new default combinations appear on the lights above the Yes ◀ and the No ▶ keys. The default is
STD/NORMAL.
