3 Getting Started “PG Operation”

3 Getting Started “PG Operation”

This chapter shows you how you can configure your PC module in PG operation. In this situation, we distinguish two modes:

SProgramming device (PG/PC)

SHMI stations

The default setting for the PC modules is PG operation.

Requirement: SIMATIC NET PC software and hardware are installed

Before you work through the steps described here, you must first install the SIMATIC NET software and the hardware on your PC station.

SInstalling SIMATIC NET PC software

Follow the procedure described in the Installation Instructions that accompany every SIMATIC NET PC module to install the products of the SIMATIC NET PC Software CD.

SInstalling hardware (PC modules)

Install the hardware in your computer as described in the Installation Instructions that accompany every module.

Commissioning PC Stations - Manual and Quick Start

41

Release 5/2005

C79000-G8976-C156-07

Page 41
Image 41
Siemens C79000-G8976-C156-07 quick start Getting Started PG Operation