3. Printing
1)Destination
This selects the output destination tray.
-Inner Tray — Select this when no finisher is installed.
-Tray 1 — Select this to route the output to the upper tray of the Finisher.
-Tray 2 — Select this to route the output to the lower tray of the Finisher.
NOTE: “Tray 1” and “Tray 2” are only available when the Hanging Finisher,
2)Hole Punch
This sets whether or not a print job is hole punched.
-Off — Select this to print without hole punches.
-Long Edge Punch without rotation — Select this to create holes on the left side for the portrait document, or on the top for the landscape document.
-Short Edge Punch without rotation — Select this to create holes on the top for the portrait document, or on the right for the landscape document.
-Long Edge Punch with 180 degree rotation — Select this to create holes on the right side for the portrait document, or on the bottom for the landscape docu- ment.
-Short Edge Punch with 180 degree rotation — Select this to create holes on the bottom for the portrait document, or on the left for the landscape document.
NOTE: This option cannot be selected if a hole punch unit is not installed.
3)Stapling
This sets whether a print job is stapled.
- Off — Select this to print without stapling.
270 | Printing Guide — Printing from Macintosh |
