Toshiba 451C, 281C, 351C manual Center Margin, Outer Margin, Collate

3. Printing

Option Value	Alternate Value	Description
left2right=on	ON	Select left to right page layout for booklet printing mode.
		This is the default setting.
		If the value is ON then the layout of the pages is from
		Left to Right as shown in the figure below.

If left2right=off then long edge binding is selected, otherwise if left2right=on then short edge binding is used.

Example: The command to select left to right page layout for booklet printing mode is “lp –o left2right=on filename”.

— Center Margin

The booklet mode center margin can be selected using the following options.

Option Value	Alternate Value	Description
centermargin		Select the center margin value for booklet printing
=value		mode.
		This value specifies in pixels the Center Margin or the
		“Gutter”. This is in addition to the center margin already
		specified by the application. The valid range for value is
		0 – 300. Default is 0.

Example: The command to select the center margin value for booklet printing mode is “lp –o centremargin=value filename”.

— Outer Margin

The booklet mode outer margin can be selected using the following options.

Option Value	Alternate Value	Description
outermargin		Select the outer margin value for booklet printing mode.
=value		This value specifies in pixels the Outer Margin or the
		“Creep” per page, which should take place while print-
		ing a booklet. The valid range for value is 0 – 18.
		Default is 0.

Example: The command to select the outer margin value for booklet printing mode is “lp –o outermargin=value filename”.

— Collate

The collate option can be selected using the following options.

Option Value	Alternate Value	Description
collate=off	OFF	Cancel the collate printing mode.
collate=on	ON	Set the collate printing mode.

Example: The command to select collate off is “lp -o collate=off filename”.

306 Printing Guide — Printing from UNIX