3. Printing

-Finisher — Select this when the Multi-staple Finisher is installed.

-Saddle Stitch Finisher — Select this when the Saddle-stitch Finisher is installed.

3)Hole Punch Unit

This sets whether or not the optional hole punch unit is installed.

-None — Select this when hole punch unit is not installed.

-2 Holes — Select this when the 2 hole punch unit is installed.

-2/3 Holes — Select this when the 2/3 hole punch unit is installed.

-4 Holes (F) — Select this when the 4 hole (F) punch unit is installed.

-4 Holes (S) — Select this when the 4 hole (S) punch unit is installed.

4)Drawer 1/Paper Type

This sets the paper size and paper type set in the 1st drawer.

5)Drawer 2/Paper Type

This sets the paper size and paper type set in the 2nd drawer.

6)Drawer 3/Paper Type

This sets the paper size and paper type set in the 3rd drawer. This can be set only when the 3rd drawer is installed.

7)Drawer 4/Paper Type

This sets the paper size and paper type set in the 4th drawer. This can be set only when the 4th drawer is installed.

8)Large Capacity/Paper Type

This sets the paper size and paper type set in the Large Capacity Feeder. This can be set only when the Large Capacity Feeder is installed.

NOTE: LCF is not available for some countries or regions.

9)Bypass Feeder/Paper Type

This sets the paper type set in the Stack Feed Bypass.

10)Memory

Select the size of memory installed.

11)Enable SNMP Communication

Check this to enable obtaining the configuration information from this equipment.

12)[Update Now]

Click this to obtain the configuration information from this equipment immediately. This is available only when “Enable SNMP Communication” is checked.

NOTE: If the connection to the equipment has not been configured correctly, the message “The address of your printer could not be located. Would you like to find it?” will be displayed when you click [Update Now]. If it is displayed, click [Yes] and search for the equipment using the TopAccessDocMon Local Discovery dialog box. After searching the equip- ment, the SNMP communication will be enabled. For the instructions on how to search the equipment, refer to the instructions of TopAccessDocMon.

P.323 "Searching for a Printer"

13)Update Automatically

Check this to update the configuration information every time the printer driver is opened. This is available only when “Enable SNMP Communication” is checked.

238

Printing Guide — Printing from Windows

Page 238
Image 238
Toshiba 281C Hole Punch Unit, Drawer 1/Paper Type, Drawer 2/Paper Type, Drawer 3/Paper Type, Drawer 4/Paper Type, 10Memory