US E R GU I D E (MA C H I N E AD M I N I S T R A T O R )
Allocate Memory
PCLe Memory
PostScript Memory
Receiving
Allocate Memory determines memory volume for the reception buffer, where the data transmitted from clients is stored, for each interface.
For LPD, SMB and IPP you can set whether or not to spool to memory, and where to spool. The assigned memory size when spooling to memory can also be configured (LPD and SMB only).
The size of the reception buffer can be changed according to machine's conditions and your requirements. If the reception buffer is increased, clients using each interface may be released quicker. The maximum value you can set changes according to the amount of available memory.
NOTE: When the memory size is changed, the memory will be reset, and the data stored in each memory area will be erased.
NOTE: If the set values exceed the size of the installed memory, the system automatically adjusts the memory allocation when the power is turned on.
NOTE: When a port is set to Disabled, corresponding items will not be displayed.
The following items can be configured in Memory Settings. Set the memory size for PCLe.
The memory size can be set between 2.50 ~ 32.00 MB, in increments of 0.25 MB.
Set the amount of memory used by PostScript. This item will be displayed only when a PostScript software kit is installed.
The memory size can be set between 8.00 ~ 32.00 MB, in increments of 0.25 MB. The maximum value depends on the amount of available memory. The default is 16.00 MB.
Set the memory size for
This item only appears when the machine is equipped with PS- ROM. The size can be set between 64 KB ~ 5120 KB, in increments of 32 KB. The maximum value depends on the amount of available memory. The default is 64 KB.
Set the receive buffer on the parallel interface.
The memory size can be set between 64 ~ 1024 KB, in increments of 32 KB. The default is 64 KB.
