US E R G U I D E (C O P I E R )
Transparencies
Transparencies can only be fed from Tray 5 (Bypass). Stripeless transparencies are recommended. Striped transparencies must be loaded with the stripe face up, on the left side of the tray.
NOTE: Use only the transparencies recommended in the Recommended Materials for the WorkCentre 24.
After loading the transparencies you can program the copier printer to insert a blank separator page between transparencies by using the Transparency Separators feature.
For more information about the Tranparency Separators feature, refer to the section entitled Transparency Separators, in this chapter.
Follow these guidelines to prevent static build up when using transparencies:
•Place no more than twenty 8.5x11 inch or A4 transparencies in Tray 5 (Bypass) at one time.
•Place only one 11x17 in. or A3 transparency in Tray 5 (Bypass) at a time.
•Remove the transparencies from the Center Output Tray before running additional sets.
NOTE: Transparencies cannot be delivered to the Finisher Tray.
For more specific information about materials that have been tested and approved for use in the WorkCentre 24, refer to the Recommended Materials for the WorkCentre 24. Information is also available off the main Xerox web site (www.xerox.com) and will be updated periodically.
