3Mount the switch assembly to the rack by inserting the three mounting hooks on one side of the bracket into square holes in the vertical rack.
4Press down until the blue push button pops out and clicks.
Figure 2-1. OU Mounting Bracket Installation
To install the
1Remove the screws on each side of the 1U
2Line up the vent holes in the “long side” of the kit’s front brackets with the vent holes in the switch.
NOTE: The switch vent holes must not be covered by the bracket, which will occur if installed on the wrong side of the switch.
3Line up the screw holes in the bracket with the screw holes in the switch.
4With a Phillips screwdriver, fasten the front mounting brackets to the switch using two screws on each side.
Installation
12
