CAUTION: To reduce the risk of electric shock or damage to your equipment, do not disable the power cord grounding plug. The grounding plug is an important safety feature. Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times. Disconnect the power from the unit by unplugging the power cord from either the electrical outlet or the unit.
NOTE: If the building has
NOTE: The maximum supported cable length from switch to device is 30 meters.
To install the Remote Console Switch hardware:
NOTE: The default username is “Admin.” There is no default password.
1Connect a terminal or PC running the terminal emulation software to the configuration port on the back panel of the Remote Console Switch using the supplied serial cable. The terminal should be set to 9600 baud, 8 bits, 1 stop bit, no parity, and no flow control.
2Plug the supplied power cord into the back of the Remote Console Switch unit and then into an appropriate power source.
3When the power is switched on, the Power indicator on the rear of the unit will blink for 30 seconds while performing a
17