Power supply fan and fan duct

Before proceeding, remove the following components:

●Toner collection unit. See Toner collection unit on page 79.

●Right rear cover. See Right rear cover on page 109.

●Left cover. See Left cover on page 111.

●Rear cover and upper rear cover. See Rear cover and upper rear cover on page 124.

NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the power supply fan.

Remove the power supply fan and fan duct

1.Disconnect one connector (callout 1; J119) and release the wire harnesses from the guide (callout 2).

NOTE: To locate DC controller connector locations, see DC controller PCA on page 284.

Figure 2-113Remove the power supply fan (1 of 4)

1

2

ENWW

Internal assemblies 147