HP Enterprise 500 manual Registration assembly, Remove the registration assembly

Registration assembly

Before proceeding, remove the following components:

●Toner collection unit. See Toner collection unit on page 79.

●Secondary transfer assembly. See Secondary transfer assembly on page 96.

●Intermediate transfer belt (ITB). See Intermediate transfer belt (ITB) on page 98.

●Right rear cover. See Right rear cover on page 109.

●Left cover. See Left cover on page 111.

●Rear cover and upper rear cover. See Rear cover and upper rear cover on page 124.

NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the registration assembly.

●RD sensor assembly. See Registration density (RD) sensor assembly on page 143.

TIP: Removing the RD sensor assembly makes it much easier to reinstall the registration assembly.

●Power supply fan and fan duct. See Power supply fan and fan duct on page 147.

Remove the registration assembly

NOTE: If a replacement registration assembly is installed, you must use the control panel menus to reset the registration-roller count.

1.Remove two screws (callout 1).

Figure 2-117Remove the registration assembly (1 of 8)

1

150 Chapter 2 Removal and replacement ENWW