NOTE: The formatter cage is attached to the low voltage power supply (LVPS). Remove both components as an assembly. You can then remove the formatter cage from the LVPS.
NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the low voltage power supply.

Low voltage power supply

Before proceeding, remove the following components:

●Toner collection unit. See Toner collection unit on page 79.

●Formatter. See Formatter PCA on page 81.

●Right rear cover. See Right rear cover on page 109.

●Left cover. See Left cover on page 111.

●Rear cover and upper rear cover. See Rear cover and upper rear cover on page 124.

●Interconnect board (ICB). See Interconnect board (ICB) on page 158.

Remove the low voltage power supply

CAUTION: ESD sensitive part.

1.Disconnect four connectors (callout 1; J100 and J101 on the DC controller PCA).

NOTE: To locate DC controller connector locations, see DC controller PCA on page 284.

NOTE: If the ICB is removed with the power supply, as noted in the above bulleted list, also disconnect one FFC (J105) on the DC controller and the connector on the top of the ICB.

Figure 2-132Remove the low voltage power supply (1 of 7)

1

ENWW

Internal assemblies 163