HP Enterprise 500 manual 184Remove the laser/scanner assembly C/Bk 7

7.Rotate the corner of the assembly away from the product until you can see the PCA, and then remove the assembly from the product.

Reinstallation tip When the laser/scanner is properly positioned in the chassis, the plastic parts which protrude at the front and rear of the product will be firmly seated against the locator tabs on the chassis. Verify that the assembly is correctly seated, and then install the spring.

Figure 2-184Remove the laser/scanner assembly (C/Bk) (7 of 7)

1

2

Reinstall the protective glass cleaner (PGC) actuators

1.The following figure shows a dislodged PGC actuator.

TIP: If the actuator and spring are only slightly dislodged, you might be able to easily push them back into place.

Figure 2-185Reinstall the PGC actuators (1 of 5)

198 Chapter 2 Removal and replacement ENWW