HP Enterprise 500 manual Fuser drive assembly, Before proceeding, remove the following components

Fuser drive assembly

Before proceeding, remove the following components:

●Toner collection unit. See Toner collection unit on page 79.

●Formatter. See Formatter PCA on page 81.

●Fuser. See Fuser on page 87.

●Secondary transfer assembly. See Secondary transfer assembly on page 96.

●Right rear cover. See Right rear cover on page 109.

●Left cover. See Left cover on page 111.

●Hardware integration pocket (HIP). See Hardware integration pocket (HIP) (dn and xh models only) on page 115.

●Control panel assembly. See Control panel assembly on page 116.

●Front top cover. See Front top cover on page 122.

●Rear cover and upper rear cover. See Rear cover and upper rear cover on page 124.

NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the fuser drive assembly.

●Rear top cover. See Rear top cover on page 127.

●Power supply fan and fan duct. See Power supply fan and fan duct on page 147.

●Interconnect board (ICB). See Interconnect board (ICB) on page 158.

●DC controller PCA. See DC controller PCA and tray on page 160.

●Low voltage power supply. See Low voltage power supply on page 163.

●High voltage power supply lower. See High voltage power supply lower (HVPS-D) on page 167.

●High voltage power supply upper. See High voltage power supply upper (HVPS-T) on page 201.

●Main drive assembly. See Main drive assembly on page 212.

ENWW Internal assemblies 223