8.Pull the fan assembly slightly out of the product, disconnect two connectors (callout 1), and then remove the assembly.

Figure 2-173Remove the laser/scanner assembly (Y/M) (8 of 12)

1

9. Remove one screw (callout 1), and then release one spring (callout 2).

CAUTION: The spring is not captive. Do not lose the spring when it is removed. Use a pair of needle-nose pliers to safely retain the spring when it is removed. Do not use a flat blade screwdriver to remove the spring; the spring could forcibly leave the product and strike you.

Reinstallation tip When the laser/scanner is properly positioned in the chassis, the plastic parts which protrude at the front and rear of the product will be firmly seated against the locator tabs on the chassis. Verify that the assembly is correctly seated, and then install the spring.

Figure 2-174Remove the laser/scanner assembly (Y/M) (9 of 12)

1

2

 

190 Chapter 2 Removal and replacement

ENWW